65% polyester/35% cotton
Twill.Do not soak.Wash separately.The product is certified to retain it qualities with 50 domestic washes or 50 industrial washes.The dirt-repellent finish is reactivated by tumble drying according to the washing instructions.
Industrial washing process for safety workwear and two-tone workwear.
Yes - if handled according to these care instructions.
Wash according to ISO 15797 - 8 covering industrial wash. Wash separately.
Refer to info on reflective garments below.
pH: Max pH 10, max alkalinity 650 mg/l. Do not use: Alkali boosters, optical brighteners, bleaching agents, detergents that contain free sodium or potassium hydroxide, solvenated surfectants. Avoid use of softeners. Max 20 min. in main wash bath.
Clarify between local legislation and chemical supplier.
Tumble dry (ISO 15797 A): Max outlet / exhaust temp 90ºC, use cool down. Cycle time: balanced to meet residual moisture content of +3%. Tunnel dry: (ISO 15797 B): Max incoming air temp 155/160ºC.
Close any zippers before washing.
Fluorescent and with reflective tape. The surface treatment makes the product dirt-repellent. Triple stitched seams at leg and crotch. Ergonomically formed trouser leg. Fly with zip. D-ring. Front pockets. Back pockets with flap. Thigh pockets with flap and hidden press studs. Each standard leg length can be lengthened by 3 cm by releasing the internal red stitching.
The product is certified with maximum 0,4000m² logo area. This approved area must not be exceeded. Logo respectively on the front or back of the product, can only constitute a maximum of 50% of the total approved logo area in order to maintain the EN ISO 20471-certification. Note: The listed area is only a guide to how much space is available for logo placement. In order to maintain the product’s hi-vis class according to EN ISO 20471, the instructions on logo size must be observed.
Measuring guide: K1 - The waist size is measured just above the navel (see measuring chart).
No liability accepted for product alterations.