Fluorescent and with vertical and oblique, transverse reflective strips. Breathable, wind and waterproof. Taped seams. CLIMASCOT® Lightweight Insulation. Padded. Quilt lining in sleeves. High collar. Ribbed inner collar. Detachable lined hood can be adjusted to fit over a helmet via drawstring. Adjustable wire on both sides of the hood. Fastening with zip and storm flap with press studs. Zipped inner pockets under storm flap - one designed especially for a mobile with holes for headset wire and guide loops to keep wire accessible. Zipped pocket under storm flap large enough to hold a 9.4-inch tablet. Chest pocket with a zip. Chest pocket with flap and press stud. D-ring. Ergonomically shaped sleeves allow for high freedom of movement. Front pockets with a zip. Internal drawstring adjustment at the hip. Zip at lower back for logo printing/ embroidery. Extended back. Waterproof pen pocket. Rib (hidden in storm flap) at cuffs. CORDURA® fabric reinforced cuffs with press stud fastening.

• OEKO-TEX® STANDARD 100 - Confidence in textiles. Tested for harmful substances.
• High-visibility warning clothing for professional use X: Indicates product’s overall class, depending on the area of the fluorescent fabric and the area of reflective tape.
• Hi-vis Group A
• EN 343:2019
• The best way to protect yourself from the cold is to use workwear that is certified in accordance with EN 342. In order to obtain maximum protection, your workwear should be kept dry and tight around openings, such as the cuffs. Each individual product is classified in accordance with different values: thermal insulation value, degree of air permeability and, if applicable, waterproofness (WP). The higher the insulation value, the better the protection. The insulation value is stated by the product. Air permeability is stated as a pictogram and is graded from 1–3 with three being the highest.

• OEKO-TEX® STANDARD 100
• EN ISO 20471 - class 3
• Hi-Vis Group A
• EN 343
• EN 342

The product is certified with maximum 0,2400m² logo area. This approved area must not be exceeded. Logo respectively on the front or back of the product, can only constitute a maximum of 50% of the total approved logo area in order to maintain the EN ISO 20471-certification. Note: The listed area is only a guide to how much space is available for logo placement. In order to maintain the product’s hi-vis class according to EN ISO 20471, the instructions on logo size must be observed.

Logo placement:

• Workwear logo. Left breast. Max 8x7 cm/3,1x2.7 inches
• Workwear logo. Mid-back. Max 25x20 cm/9.8x7.8 inches
• Workwear logo. Horizontal on right sleeve. Max 10x5 cm/3.9x1.9 inches
• Workwear logo. Special placement. Contact to discuss further