92% polyester/8% elastane
ULTIMATE STRETCH.Shrinkage max. 2%.The product is certified to retain its qualities with 50 domestic washes.
Wash according to ISO 6330. Wash together with similar textiles/colours.
Wash gently < 40ºC.
Comply to chemical suppliers recommendations for specific textile categories. Avoid use of bleaching agents on coloured textiles. Avoid use of softeners.
pH: Max pH 10, max alkalinity 650 mg/l. Do not use: Alkali boosters, optical brighteners, bleaching agents, detergents that contain free sodium or potassium hydroxide, solvenated surfectants. Avoid use of softeners. Max 20 min. in main wash bath.
Clarify between local legislation and chemical supplier.
Close any zippers before washing.
Fluorescent contrast colour and with reflective tapes. Has a water-repellent finish. Two-toned. ULTIMATE STRETCH fabric that is lightweight and durable. Double stitched seams on leg and crotch. Hidden stud fastening. Ergonomically formed trouser leg. Belt loops. D-ring. Fly with zip. Front pockets. Back pockets with reinforcement. Adjustable hammer loop. Reinforced ruler pocket. Button for knife attachment. Thigh pockets with flaps. Adjustable kneepad pockets in durable CORDURA® (500 D). Thigh pocket with phone pocket and flap with hook and loop band fastening. With print effects. Prepared for holster pockets 19450-126, which are attached with buttons. Each standard leg length can be lengthened by 3 cm by releasing the internal red stitching. We recommend 00418-100, 00718-100, 50451-916 and 20118-915 kneepads for this model. Co-certified together with kneepad type SHORT or LONG in accordance with EN 14404.
As the product is made of stretch material, a stretchable transfer must be used when printing on the product. You should choose a transfer that can be heated at a maximum of 145 degrees with consideration to print on the product. Remember to check the washing instructions for the chosen transfer before washing the product.
The product is certified with maximum (82+90 cm) 0,0500 m² (76 cm) 0,0300m² logo area. This approved area must not be exceeded. Logo respectively on the front or back of the product, can only constitute a maximum of 50% of the total approved logo area in order to maintain the EN ISO 20471-certification. Note: The listed area is only a guide to how much space is available for logo placement. In order to maintain the product’s hi-vis class according to EN ISO 20471, the instructions on logo size must be observed.
Measuring guide: K1 - The waist size is measured just above the navel (see measuring chart).
No liability accepted for product alterations.