Functional Trousers
MASCOT® REworked
ULTIMATE STRETCH
Work Trousers
Workwear
65% polyester/35% cotton
290 g/m²
Twill.Do not soak.Wash separately.The product is certified to retain it qualities with 50 domestic washes or 50 industrial washes.The dirt-repellent finish is reactivated by tumble drying according to the washing instructions.
Description
Industrial washing process for safety workwear and two-tone workwear.
Pro Label
Yes - if handled according to these care instructions.
Wash process
Wash according to ISO 15797 - 8 covering industrial wash. Wash separately.
Wash temperature
Max 75ºC.
Wash chemistry
Refer to info on reflective garments below.
Reflective garments
pH: Max pH 10, max alkalinity 650 mg/l. Do not use: Alkali boosters, optical brighteners, bleaching agents, detergents that contain free sodium or potassium hydroxide, solvenated surfectants. Avoid use of softeners. Max 20 min. in main wash bath.
Disinfection
Clarify between local legislation and chemical supplier.
Drying process
Tumble dry (ISO 15797 A): Max outlet / exhaust temp 90ºC, use cool down. Cycle time: balanced to meet residual moisture content of +3%. Tunnel dry: (ISO 15797 B): Max incoming air temp 155/160ºC.
Zippers
Close any zippers before washing.
Fluorescent and with reflective tape. One-tone. The surface treatment makes the product dirt-repellent. Triple stitched seams at leg and crotch. Ergonomically formed trouser leg. Low waist and form cut waist band. Belt loops. Fly with zip. D-ring. Front pockets. Back pockets with reinforcement, flap and hidden press studs. Adjustable hammer loop. Reinforced thigh pocket with additional pockets; an inner phone pocket as well as an external phone pocket with flap and magnetic closure. Ruler pocket. Kneepad pockets in durable CORDURA® (500 D). We recommend 00418-100 kneepads for this model. Co-certified together with kneepad type SHORT in accordance with EN 14404.
The product is certified with maximum 0,0900m² logo area. This approved area must not be exceeded. Logo respectively on the front or back of the product, can only constitute a maximum of 50% of the total approved logo area in order to maintain the EN ISO 20471-certification. Note: The listed area is only a guide to how much space is available for logo placement. In order to maintain the product’s hi-vis class according to EN ISO 20471, the instructions on logo size must be observed.
Logo placement:
Measuring guide: K2 – The waist size is measured just under the navel (see measuring chart).
Leg length 53 cm (21 inches).
No liability accepted for product alterations.