Fluorescent and with vertical and oblique, transverse reflective strips. Two-toned. Very breathable, wind and waterproof. Taped seams. Detachable lined hood with adjustable drawstring. Fastening with waterproof zip and internal storm flap. Inner pocket - two with zips and one open mesh. Detachable ID card holder. Chest pocket with waterproof zip. Front pockets with waterproof zips. High collar. Rib inside the bottom trim on the front of the jacket. Flap on back of jacket can be folded up for standard back length or released for extended back. Elastic at cuffs. With print effects.

• OEKO-TEX® STANDARD 100 - Confidence in textiles. Tested for harmful substances.
• High-visibility warning clothing for professional use X: Indicates product’s overall class, depending on the area of the fluorescent fabric and the area of reflective tape.
• High-visibility warning clothing for professional use X: Indicates product’s overall class, depending on the area of the fluorescent fabric and the area of reflective tape.
• Hi-vis Group A
• When there's a job that needs to be done whatever the weather, it's important to be properly dressed. EN 343 is used to add different values to clothing that protects against the rain. Next to the symbol are three values. The first number indicates the water tightness, and the second number refers to the breathability of the overall product. Both values are divided into classes from 1-4, with 4 indicating the highest class. The lowest value is an optional test of the finished product to test the impact of rainfall from above. R indicates that the product has been tested, X indicates that the product has not been tested.

• OEKO-TEX® STANDARD 100
• EN ISO 20471 - class 3
• EN ISO 20471 - class 2 (S)
• Hi-Vis Group A
• EN 343 4-4-X

You should choose a transfer that can be heated at a maximum of 145 degrees with consideration to print on the product. Remember to check the washing instructions for the chosen transfer before washing the product.

The product is certified with maximum (M-5XL) 0,0400 m² (S) 0,2800m² logo area. This approved area must not be exceeded. Logo respectively on the front or back of the product, can only constitute a maximum of 50% of the total approved logo area in order to maintain the EN ISO 20471-certification. Note: The listed area is only a guide to how much space is available for logo placement. In order to maintain the product’s hi-vis class according to EN ISO 20471, the instructions on logo size must be observed.

Logo placement:

• Workwear logo stretch. Over left breast pocket. Max 9x3 cm/3.5x1.1 inches
• Workwear logo stretch. Right breast pocket. Max 8x7 cm/3.1x2.7 inch
• Workwear logo stretch. Mid-back. Max 20x20 cm/7.8x7.8 inches
• Workwear logo stretch. Horizontal on right sleeve. Max 10x5 cm/3.9x1.9 inches
• Workwear logo. Special placement. Contact to discuss further